Suntec A2RA-7720 Waste Oil Pump 0.4-2.5 GPH 10/100 PSI 1725/3450 RPM
Specifications:
A - Single Stage
2- 3450 RPM
R - 30 X 30 Mesh
A- R.H. Rotation - R.H. Nozzle
77 - Hub 54 mm, Lip Seal
20 - Mounting Style and Standard Pumps
This Pumps Is Rated For Waste Oil, Number 4 (# 4) and Lighter Fuel Oils
Separate Regulator And Shutoff Required
Specifications: Inlet port (std) 1/4 NPTF
Alt. Inlet port 1/4 NPTF
Nozzle outlet (non plug in side) 1/8 NPTF
Alt. nozzle port#1 (gauge port) 1/8 NPTF
Alt. nozzle port#2 (side opposite bleeder) 1/8 NPTF
Relief valve port 1/8 NPTF
Pressure gauge port 1/8 NPTF
Bleeder valve port 1/8 NPSF
External pressure regulator needed Yes
Cut-off at nozzle plug port No cut-off - separate shut-off valve is required
Cut-off at alternate nozzle plug port No cut-off - separate shut-off valve is required
Strainer (internal to pump, from SUNTEC) 30x30 mesh (build into pump)
Strainer (external to pump, from Installer) 100x100 mesh inlet line strainer min. 10 micron highly recommended
Shaft diameter 5/16 in
Hydraulic Data
Nozzle pressure range 0-15 psi @ 135 rpm, 0-30 psi @ 1725 rpm, 0-150 rpm @ 3450 rpm
Relief pressure 60 +/-10 psi - Caution: Relief valve port must be open to tank or unsafe pressures can result !
Factory pressure setting N/A - Separate pressure regulator & shutoff valve required.
Outlet flow rate (Gph) 0.40 @ 10 psi & 135 rpm, 2.5 max @ 110 psi & 1725 or 3450 rpm.
Oil temperature 50 - 115 F
Inlet pressure 10 psi max
Operating vacuum 20" Hg max.(waste oil and #4 fuel) 10" Hg max.(#2 and lighter fuel) to prevent air separation from oil
Motor Speed 100 rpm to 3450 rpm Required Motor HP 1/8 HP 1725 rpm, 1/7 HP 3450 rpm
Recommended inlet line length (Ft) 1/2" line 20' max, 3/4" line 90'max.Lift (FT)
Waste oil & fuel equivalent to No. 4: 14" max. No. 2 & lighter fuel oil: 8' max.
A2RA7720 Is The Same As CleanBurn 32475, Clean Burn 32475
